Brick Masonry
Trusted Brick Contractors in Thunder Bay, ON
Thunder Bay Masonry Pros has been laying and repairing brick across Thunder Bay for over 25 years. A new wall or facade changes how a place looks, but it only holds if it sits on the right base, gets built to standard, and is finished cleanly. We do the new work and the repairs, and we build both to get through the winters here.
- Chimney rebuilds & repairs
- Foundation repair
- Home exteriors & facades
- Tuckpointing & mortar repair
- Steps & entryways
- Outdoor fireplaces
- Commercial brick facades
- Pillars & columns
- Window & door surrounds
- Retaining walls
We Understand The Weather
A wall or veneer has to do more than look good on day one. It has to carry load, shed water, and stay put through years of freeze and thaw. We build to that standard and keep older work protected with timely repairs, so the structure underneath stays sound.
How We Do Brick Repairs in Thunder Bay, ON
Most repairs that fail early fail because the mortar mix was wrong, so we work in a set order and don’t rush the part that matters:
- Assess what’s actually failing, the joints, the units, or both.
- Rake out the failed mortar and brush the joints clean.
- Repack with a mix matched to the original in colour, strength, and composition.
- Replace any spalled units with the closest match we can source.
- Tool the joints so the repair blends into the surrounding wall.
What It Costs
It depends on what we find: the size of the area, how much is repointing versus replacement, the height of the wall, and how easy it is to reach. A small repointing job runs a few hundred dollars; a full facade or a structural rebuild is well beyond that. We quote it after we’ve seen it, not over the phone where the number changes once we show up.
How We Do Brick Repairs in Thunder Bay, ON
Most repairs that fail early fail because the mortar mix was wrong, so we work in a set order and don’t rush the part that matters:
- Assess what’s actually failing, the joints, the units, or both.
- Rake out the failed mortar and brush the joints clean.
- Repack with a mix matched to the original in colour, strength, and composition.
- Replace any spalled units with the closest match we can source.
- Tool the joints so the repair blends into the surrounding wall.
Frequently Asked Questions
How long does brick last?
A unit can last a century or more. The mortar holding it together usually needs attention every 25 to 30 years, which is where tuckpointing comes in. Keep the joints up and the wall lasts far longer.
What causes bricks to fail?
Water and time, mostly. Moisture works into worn joints, and our winters do the rest as it freezes and thaws season after season. Sound joints, decent drainage, and not letting small problems sit are what keep a wall standing.
When should I repair brick instead of replacing it?
It comes down to what’s failing. Solid units with bad joints get repointed; spalled or cracked faces get replaced. We give you the honest answer, not the expensive one by default.
Can you match my existing brick?
Often, yes. An exact match on older work isn’t always possible, but with the right sourcing we get close, and on a visible repair we do everything we can to blend it.
How do I know if my brick needs repair?
Look for crumbling or missing joints, cracks through the mortar lines, water stains inside or out, or flaking on the face. Any of those is worth a look before it spreads.